ITech IT8625 - Chapter 4 Load Functions; Load Function Overview and AC Load Functions

System Commands
Copyright © Itech Electronic Co., Ltd. 44
Query Syntax:
SYSTem:COMMunicate:LAN:CURRent:DGATeway?
Returned value:
<STR>
SYSTem:COMMunicate:LAN:CURRent:SMASk
This command is used to set the load subnet mask.
Command syntax:
SYSTem:COMMunicate:LAN:CURRent:SMASk
Parameter:
<STR>
Unit:
None
Reset value:
255.255.255.0
Query Syntax:
SYSTem:COMMunicate:LAN:CURRent:SMASk?
Returned value:
<STR>
SYSTem:COMMunicate:LAN:DHCP
This command is used to determine whether set up the dynamic IP address.
Command syntax:
SYSTem:COMMunicate:LAN:DHCP[:STATe] <bool>
Parameter:
0|1|0FF|ON
Query Syntax:
SYSTem:COMMunicate:LAN:DHCP[:STATe]?
Returned value:
0|1