Common Commands
Copyright © Itech Electronic Co., Ltd. 63
*RCL
This command restores the electronic load to a state that was previously
stored in memory with a *SAV command to the specified location.
Command syntax
*RCL <NRf>
Parameter
0～9
*TST？
This query causes the electronic load to do a self-test and report any errors.
0 indicates the load passes its self test. Non-zero indicates an error code. In
addition, a false information will be generated when the test fails.
Query Syntax:
*TST？
Parameter:
None
Returned value:
<NR1>
To Next Page
Loading...
