ITech IT8625 - Rear Panel Introduction and Power-on Self-test

To Next Page

To Previous Page

Measurement Commands

MEASure:VOLTage?

FETCh:VOLTage?

This command is used to read the voltage value.

Command syntax:

MEASure[:SCALar]:VOLTage[:DC]?

FETCh[:SCALar]:VOLTage[:DC]?

Returned value:

<NR3>

MEASure:VOLTage:RMS?

FETCh:VOLTage:RMS?

This command is used to read the voltage effective value.

Command syntax:

MEASure[:SCALar]:VOLTage:RMS?

FETCh[:SCALar]:VOLTage:RMS?

Returned value:

<NR3>

MEASure:VOLTage:MAXimum?

FETCh:VOLTage:MAXimum?

This command is used to read the maximum voltage value.

Command syntax:

MEASure:[SCALar:]VOLTage:[AMPLitude:]MAXimum?

FETCh:[SCALar:]VOLTage:[AMPLitude:]MAXimum?

Returned value:

<NR3>

Other manuals for ITech IT8625