ITech IT8625 - System:beeper:immediate; System:beeper; System:version

System Commands
Copyright © Itech Electronic Co., Ltd. 46
SYSTem:BEEPer:IMMediate
This command is used to test the beeper. The AC load will beep for once after
executing this command.
Command syntax:
SYSTem:BEEPer:IMMediate
Parameter:
None
Query Syntax:
None
SYSTem:BEEPer
This command is used to turn on or turn off the beeper. When the parameter is
set to 1|ON, the beeper turns on, or the beeper turns off.
Command syntax:
SYSTem:BEEPer[:STATe] <bool>
Parameter:
0|OFF|1|ON
Query Syntax:
SYSTem:BEEPer[:STATe]?
Returned value:
0|1
SYSTem:VERSion?
This command is used to query the device version. Return value is a character
string as like.”YYYY.V”.YYYY represents the year and V means the version of
that year.
Command syntax:
SYSTem:VERSion?
Parameter:
None