System Commands
Copyright © Itech Electronic Co., Ltd. 48
SYSTem:RWLock
This command is used to set AC load to remote control mode via RS232
communication interface. And Local button is not available. After this command
is executed, set the mode of AC load to remote.control mode. But unlike
SYST:REM command, all the keys on the front panel including Local key will be
locked.
Command syntax:
SYSTem:RWLock
Parameter:
None
Returned value:
None
SYSTem:BACKlight:BRIGhtness
This command is used to set the brightness of backlight.
Command syntax:
SYSTem:BACKlight:BRIGhtness <NR1>
Parameter:
NR1
Parameter range:
1 to 9
Query Syntax:
SYSTem:BACKlight:BRIGhtness?
Returned value:
<NR1>
To Next Page
Loading...
