ITech IT8625 - Rst; Sre

Common Commands
Copyright © Itech Electronic Co., Ltd. 61
Parameter
None
Query Syntax
*OPC?
Returned value
<NR1>
*RST
This command reset the device to factory default setup.
Command syntax
*RST
Parameter
None
*SRE
This command sets the condition of the Status Request Enable Register. After
executing this command, AC load will return back a decimal value which is a
binary weighted sum of all bits from the enable register.
Command syntax
*SRE <NRf>
Parameter
0～255
Power-on Value
Refer to *PSC command
Example
*SRE 128
Query Syntax
*SRE?
Returned value
<NR1>