ITech IT8625 - Chapter 5 Measurement Functions; Interface Introduction and Parameter Measurement (AC;DC Modes)

Calibration Commands
Copyright © Itech Electronic Co., Ltd. 56
Parameter:
P1|P2|P3|P4
CALibrate:VOLTage:METer
This command is used to calibrate the measurement voltage level.
Command syntax:
CALibrate:VOLTage:METer[:LEVel] <NRf>
Parameter:
NRf, external reading
Unit:
V
CALibrate:CURRent:METer:POINt
This command is used to calibrate the measurement current point.
Command syntax:
CALibrate:CURRent:METer:POINt <point>
Parameter:
P1|P2|P3|P4
CALIbrate:CURRent:METer
This command is used to calibrate the measurement current level.
Command syntax:
CALibrate:CURRent:METer[:LEVel] <NRf>
Parameter:
NRf
CALibrate:RESistance:POINt
This command is used to calibrate the measurement resistance point.
Command syntax:
CALibrate:RESistance:POINt <point>