ITech IT8625 - Measure:type; Rate:DCCV

Load Commands
Copyright © Itech Electronic Co., Ltd. 31
Unit:
S
Reset value:
MINimum
Query Syntax:
[SOURce:]INPut:TIMer:DELay? [MINimum|MAXimum]
Returned value:
<NR3>
MEASure:TYPE
This command is used to set the measurement type of electronic load.
Command syntax:
[SOURce:][INPut:]MEASure:TYPE
Parameter:
METer|HARMonic|SCOPe
Reset value:
METer
Query Syntax:
[SOURce:][INPut:]MEASure:TYPE?
Returned value:
METer|HARMonic|SCOPe
RATE:DCCV
This command is used to set the load rate in CV mode under DC working
mode.
Command syntax:
[SOURce:]RATE:DCCV <SLOW|HIGH>
Parameter:
SLOW|HIGH