ITech IT8625 - Measure:voltage:thdistort; Fetch:voltage:thdistort; Measure:etime; Fetch:etime

Measurement Commands
Copyright © Itech Electronic Co., Ltd. 15
MEASure:VOLTage:THDistort?
FETCh:VOLTage:THDistort?
This command is used to read the total harmonic distortion of voltage.
Command syntax:
MEASure:[SCALar:]VOLTage:THDistort?
FETCh:[SCALar:]VOLTage:THDistort?
Returned value:
<NR3>
MEASure:ETIMe?
FETCh:ETIMe?
This command is used to read the measurement value of time and the unit is s.
Command syntax:
MEASure:[SCALar:]ETIMe?
FETCh:[SCALar:]ETIMe?
Returned value:
<NR3>
MEASure:TEMPerature?
FETCh:TEMPerature?
This command is used to read the measurement value of temperature.
Command syntax:
MEASure[:SCALar]:TEMPerature?
FETCh[:SCALar]:TEMPerature?
Returned value:
<NR3>
MEASure:CURRent:AMPLitude:HOLD
This command is used to set the update mode of measuring extremum.