Chapter 3 Installing the Collector or Repeater
To connect cables
1. The GPS cable has an SMA connector on one end and a TNC connector on the other
end. Connect the SMA connector end of the GPS antenna cable to the collector or
repeater. Connect the TNC end of the GPS cable to the external GPS antenna.
2. The WAN cable has an N connector on each end. Connect one end of the WAN
antenna cable to the collector. Connect the other end of the cable to the external WAN
antenna.
Note Repeaters do not use WAN antennas.
3. If you are using a remote 900 MHz antenna, attach the 900 MHz antenna cable to the
connector on the top of the collector or repeater. This connection must be
weatherproofed as described in the following steps.
a. Attach the coaxial cable to the top of the collector.
30 TDC-0971-011 CCU 100 and Repeater 100 Installation Guide
Proprietary and Confidential
To Next Page
Loading...