Chapter 3 Installing the Collector or Repeater
1. Attach the TCU to the TCU mounting plate.
a. Insert the TCU mounting disc into the mounting plate keyhole.
b. Slide the TCU down until you feel it click into place.
2. Connect the cable from the TCU to the RF filter.
3. Connect the ground wire to the TCU.
4. (Optional) Connect the Ethernet cable to the TCU and the top of the 10/100 BT SPD.
Feed the external Ethernet cable through the Roxtec block and connect it to the
bottom of the 10/100 BT SPD.
Instructions for using a Roxtec Block are supplied in the TCU cabinet.
42 TDC-0971-011 CCU 100 and Repeater 100 Installation Guide
Proprietary and Confidential
To Next Page
Loading...