5. Connect the battery to the connector on the battery door of the TCU.
The battery door connection is only present on collectors designed for TCU
installations.
6. Feed the GPS and WAN (if required) antenna cables through the Roxtec block and
connect them to the TCU.
7. Connect the power cable to the TCU.
8. For instructions on installing the antennas, see Attaching the External GPS/WAN
Antennas on page 20.
9. Connect power to the cabinet. See the wiring diagram on the inside of the cabinet
door. Provide power to the cabinet using electrical conduit. Itron recommends using a
knockout punch and die (such as a Greenlee® Slug-Buster®) to punch the appropriate
sized hole in the bottom of the cabinet.
TDC-0971-011 CCU 100 and Repeater 100 Installation Guide 43
Proprietary and Confidential
To Next Page
Loading...