Important: Y
ou must twist—not wrap—the cable armor onto the pit module cable.
Wrapping the cable armor can cause the stainless steel jacket to warp. You must begin
twisting the cable armor over portion of the cable protected by the electrical tape. If you
do not begin to twist the cable armor over the protected portion of the pit module cable, a
cut cable could cause an pit module/register communication failure.
5. Continue to twist the cable armor onto the pit module cable until the cable armor covers
the entire cable.
6.
Remove any leftover materials from the customer premises. Discard or recycle leftover
materials.
Using the Itron Cable Armor
OpenWay Riva Water Pit Module Installation Guide TDC-1743-004 33
Proprietary and Confidential
To Next Page
Loading...
