Carefully tighten the screw until snug. Over-tightening the mounting screw could damage
the pit module housing.
Note: If the mounting location requires a screw anchor, mark the location of the bottom
anchor and remove the pit module. Drill the required mounting hole, insert the anchor,
and re-attach the pit module.
8. Holding the pit module in the upright position, drill the second pilot hole. Use the bottom
mounting hole as a template.
Caution:
Any pit module position other than upright will negatively affect radio
performance.
9. Screw the bottom screw into the pilot hole until snug. Do not over-tighten the mounting
screw.
Wall mounting the OpenWay Riva pit module is complete.
Leak Sensor (OLS) installation with the pit water
module
Installation of the OLS with a pit water module requires the OLS with an inline connector
(Itron part number LDS-1601-001). The OLS connects to the telemetry connector on the pit
module. For pit module installation instructions, see the installation guide for your water
module. For more information, see Related documents.
Installing the OpenWay Riva Water Pit Module
OpenWay Riva Water Pit Module Installation Guide TDC-1743-004 24
Proprietary and Confidential
To Next Page
Loading...
