Warning: Crimping the connector forces some sealant out of connector. The
sealant protects the inside of the connector against insects, moisture, and other
contaminants. The sealant may cause minor eye and skin irritation. Avoid eye
contact. Avoid prolonged or repeated skin contact. Contact Itron Support for
Safety Data Sheets (SDS).
5. After the water module to register or meter wire connections are completed, arrange the
connectors in a single file.
6. Insert the connectors and wires into the splice tube until the connectors and wires are
completely immersed in the non-conductive gel material.
7. Separate the cable wires to the sides and close the splice tube cover.
Completing Gel-cap Connections Using the Itron Splice Kit
OpenWay Riva Water Pit Module Installation Guide TDC-1743-004 37
Proprietary and Confidential
To Next Page
Loading...
