ITRON SL7000 - Alarms; Alarms Description

User Guide SL7000 IEC7
114
PWR_FAIL_APPEARANCE
Power fail appearance (see note 3 below)
POWER_UP
Power up
PROGRAMMING CM
Data programming via communication
PROGRAMMING DI
Data programming via push button
CANCEL_PROGRAMMING_DI
Cancellation of data programming via push button
RESET_MEASUREMENT_DATA
Reset of measurement data
START_MEASUREMENT
Start measurement
STOP_MEASUREMENT
Stop measurement
START_TRIGGERED_TESTS
Start triggered tests
STOP_TRIGGERED_TESTS
Stop triggered tests
END_OF_CURRENT_DATA_SAVING
End of current data saving
LOAD_PROFILE_RESET
Load profile reset
PASSWORD RESTORATION
Password restoration
INDEX_CLOCK_LOSS
Default clock loss index
SUCCESSFUL COMMUNICATION
Successful communication
PROGRAMMING_CM2
Data programming via communication
THD_DEFECT
THD upper the defined threshold
START_WAVE_FORM
Launch of the waveform calculation (script)
RESET_DIPS_NUMBER
Reset of DIPS number
Note
Event
Comment
1
PARAMETERS_SAVING
Recorded each time new configuration parameters have
been programmed into the meter.
2
AC_FAIL_APPEARANCE
AC_FAIL_DISAPPEARANCE
Recorded when a micro power failure (<=1 second) is
detected by the meter, at the same time the state of power
supply backup is checked.
3
PWR_FAIL_APPEARANCE
Recorded when the meter cut calculation reaches the
lower threshold, all meter data is then saved.
10.2. Alarms
10.2.1. Alarms description
The following table contains a list of alarms (these may change due to meter firmware revision):
Non-fatal alarm
Type
Description
WATCHDOG ACTIVITY
Trapped
Watchdog
(see note 1 below)
EXTERNAL CLOCK INCOHERENCE
Trapped
Meter clock programming error
(see note 2 below)
CONFIGURATION INCOHERENCE
Trapped
Incoherence of configuration parameters
(see note 3 below)