ITW Dynatec Programming Page 5-39
V6 DCL Touch Screen Controller for Dynamelt M & D ASUs Revised 1/16
Support
To go to this screen, press the General Settings button on the Settings Screen.
Use the Customer Zone Names Editor program (provided on CD) and a thumb drive (not
provided) to make changes.
Item Description
1
Parameter Selection tabs
The Support tab has been selected.
2
If requested by ITW Dynatec Support you can insert USB Flash Drive to create a system dump
file. This file can be send to ITW Dynatec for offline diagnostics.
3 Press the left-pointing arrow to go to the previous General Settings screen.
4 Press the right-pointing arrow to go to the next General Settings screen.
5 Press the OK button to confirm your entered values and return to the previous screen.
6 Press the ESC button to discard any non-confirmed values and return to the previous screen.
To Next Page
Loading...
