ITW Dynatec DYNAMELT D25 Series - Page 123

ITW Dynatec Programming Page 5-47
V6 DCL Touch Screen Controller for Dynamelt M & D ASUs Revised 1/16
Item Description
1
Section Access
Press the buttons to select access to each parameter as follows:
• Unlock = the parameter may be changed by all users.
• Operator = the parameter may be changed by Operator personnel only, by using an
Operator password.
• Maintenance = the parameter may be changed by Maintenance personnel only, by using a
Maintenance password.
2 Press the OK button to confirm your entered values and return to the previous screen.
3 Press the ESC button to discard any non-confirmed values and return to the previous screen.
4
Change Maintenance Password Button
Touch the Change Password button and a numeric entry keypad will appear. Enter desired
numeric password (at least one digit). Press OK to confirm.
5
Change Operator Password Button
Touch the Change Password button and a numeric entry keypad will appear. Enter desired
numeric password (at least one digit). Press OK to confirm.
1
2
3
4
5