ITW Dynatec
D15/D25/D45 V6 DC L ASU Manual #20-63
Installation Page 3-15
Revised 10/14
b. If Pump is in Manual Mode:
i. Select the pump for programming under the Settings column on the Pump O verview Screen.
ii. Set the manual setpoint value (RPM) under Manual Mode Settings.
iii. Select t he next pump ( if applicable) under the Settings column on the Pump Overview
Screen. Repeat steps i thru iii until all pumps in the system are programmed.
Shut Down Procedures
At the pump screen:
1.If Pump is in Auto Mode:
a. Press STOP o r ALL PUMPS STOP.
b. Turn OFF the Main Disconnect Switch.
2. If Pump is in Manual Mode:
a. Press STOP o r ALL PUMPS STOP.
b. Turn OFF the Main Disconnect Switch.
3. If the Scheduler is in use:
Turn OFF the unit with the Control Switch On/Off (ie, on the Main Screen, press the Control but-
ton. Then, at the Control Switch/ Standby Screen, press On/Off).
Note: If the Scheduler is not in operation, use the Main Disconnect Switch to turn the unit OFF to
avoid unexpected A SU activation in the event of a power outage.
To Next Page
Loading...
