ITW Dynatec
D SERIES V6 DCL ASU Manuals
LCD Programming Page 5-27
Revised 10/14
?
TEMP SENS FAULT PRESS
Advance to the temperature zones display to see which zone is affected. The two status lines shown
above will alternate in this mode. As seen above, the question mark is placed on the zone with the
faulty sensor (ie, Head #1). After troubleshootin g the fault (reference the Error Indication Alarm
Troubleshooting Guide on the previous pages of this chapter) and solving the problem with the
sensor, press the RETURN button.
Or, if Head #1 is not in use, press F5 to turn the zone Off.
?
TEMP SENS FAULT PRESS
F5 = Zone Off
Status
Status
To Next Page
Loading...
