Table of Contents
4
5 Initial Operation 37
5.1 Connecting the device to the power supply 37
5.2 Connecting PrograMill One to the local network (LAN) 38
5.3 Switching on the tablet 39
5.4 Connecting the tablet to the network via WLAN 39
5.5 Switching on PrograMill One (for the first time) 39
5.6 Connecting the tablet and PrograMill One 40
5.7 Removing the transport protection and preparing for initial operation 41
5.8 Using the app on other mobile devices 49
6 Operating the Operating Panel 50
6.1 Starting the app 50
6.2 Overview of the [PrograMill One] app 51
6.3 Main menu [One] 53
6.4 Main menu [Cases] 56
6.5 Main menu [ToDo] 66
6.6 Main menu [Service] 71
7 Editing Milling Jobs 81
7.1 Special procedure to process zirconium oxide 81
7.2 Changing/Refilling the water in the main tank and changing the filter 83
7.3 Preparing milling jobs 89
7.4 Starting individual milling jobs (Single mode) 107
7.5 Starting several milling jobs (Multi mode) 108
7.6 Performing an emergency stop 111
7.7 Completing / unloading the finished milling job 112
7.8 Deleting a not required milling job 114
7.9 Shutting the device down and switching it off 115
8 Device Messages and Troubleshooting 116
8.1 OSD ring status 116
8.2 Messages in the app 117
8.3 Troubleshooting / error table 117
8.4 Manually registering a non-identified block 121
8.5 Manually registering a non-identified tool 123
To Next Page
Loading...