Safety
16
2.7 Safety instructions for potential hazard areas
2.7.1 Electromagnetic waves
This equipment may cause interference to radio communications or may interfere with the
operation of equipment in the vicinity.
To avoid injury to the user, never remove the housing covers.
Do not use devices that generate electromagnetic waves together in the same room as this
PrograMill One.
Take appropriate measures in the case of radio interference, e.g. a new orientation, a new
device position of PrograMill One or isolating measures.
Only use the original accessories recommended and supplied by the manufacturer. Failure
to do so can result in increased interference emissions or decreased immunity of
PrograMill One.
2.7.2 Mechanics
Whilst the device is in operation, there are the following risks in the milling chamber or in the
material and tool changer:
• Risk of crushing
• Cutting injuries caused by tools
• Damage to the machine
To avoid injury to the user from inside the unit, never remove the covers.
Do not reach into the material and tool changer via the loading aid or the shaft.
Only reach in the milling chamber in the safe maintenance mode and for cleaning
purposes (“Cleaning and Maintenance Work for the User”, page 125).
2.7.3 Sound emission
The sound emission strongly varies depending on the material being processed and the
milling conditions (“Classifications”, page 136).
In the case of higher sound emissions, which may damage your hearing:
Visually inspect the tool.
If loud operating noise cannot be prevented (sound level ≥ 80 dB(A)), use hearing
protectors during milling (“Personal protective equipment”, page 13).
To Next Page
Loading...