Editing Milling Jobs
82
NOTICE! Processing of zirconium oxide after e.max without prior manual cleaning / tank
change.
Damage to the zirconium oxide blocks.
Faulty shade of zirconium oxide.
When processing zirconium oxide after milling jobs of the material type “e.max”, manual
cleaning must be performed.
Use the additional tank for zirconium oxide.
Observe the stipulations about filling the tank.
Do not use the main tank for zirconium oxide.
For reasons of safety, the Wizard in the app guides you step by step through the individual
steps.
The tanks are identical with the exception of their colour-coding. Preparation, insertion and
removal is done the same way. The filter change is also identical.
No. Designation Type of material Coolant fluid
1 Main tank with red
colour code
For all materials with the
exception of zirconium
oxide
Distilled water (according
to VDE0510) and
PrograMill Fluid for One
2 Additional tank with
yellow colour code
Exclusively for zirconium
oxide
Exclusively distilled water
(according to VDE0510)
To Next Page
Loading...