Jackson Labs Micro-JLT GNSS - DIAGnostic Subsystem Overview; DIAGnostic:ROSCillator:EFControl:RELative? Query; DIAGnostic:ROSCillator:EFControl:ABSolute? Query; DIAGnostic:LIFetime:COUNT? Query

© 2019 Jackson Labs Technologies, Inc. 39
Micro-JLT GNSS™ User Manual
PTIMe:STAMp:DIFFer?
PTIMe:STAMp:FILTer?
PTIMe:STAMp:FILTer:PPSecond?
PTIMe:STAMp:FILTer:1PPeriod?
PTIMe:STAMp:LAST?
3.5.22 PTIMe?
The PTIMe? command is unrelated to OCXO disciplining. For more information on OCXO
disciplining, please refer to Section 3.6 .
This query returns the results of the following queries at once:
PTIMe:DATE?
PTIMe:TIME?
PTIMe:STAMp:LAST?
PTIMe:TINTerval?
PTIMe:OUTput?
PTIMe:LEAPsecond:ACCumulated?
3.6 SYNChronization Subsystem
The SYNChronization subsytem is unrelated to the Micro-JLT GNSS™ time-stamping subsystem.
For more information on time-stamping, please refer to Section 3.5.11 .
This subsystem regroups the commands related to the synchronization of the Micro-JLT GNSS™
with the GNSS receiver. The list of the commands supported for this subsystem is the following:
SYNChronization:HOLDover:DURation?
SYNChronization:HOLDover:INITiate
SYNChronization:HOLDover:RECovery:INITiate
SYNChronization:SOURce:MODE <GPS|EXTernal|AUTO>
SYNChronization:SOURce:MODE:EDGE <NEGative|POSitive>
SYNChronization:SOURce:STATE?
SYNChronization:HOLDover:STATE?
SYNChronization:TINTerval?
SYNChronization:TINTerval:THReshold <int> [50,2000]
SYNChronization:IMMEdiate
SYNChronization:FEEstimate?
SYNChronization:LOCKed?
SYNChronization:OUTput:1PPS:RESET <ON|OFF>
SYNChronization:OUTput:1PPS:RESET?
SYNChronization:OUTput:1PPS:WIDTH <int> <ms | us> [100us, 500ms]