Jackson Labs Micro-JLT GNSS - 7 Revision History; Revision Table

© 2019 Jackson Labs Technologies, Inc. 75
Micro-JLT GNSS™ User Manual
Revision History
7.1 Revision Table
Revision history of the Micro-JLT GNSS™ User Manual is listed in Table 7.1.
Table 7.1 Revision History
Document ID Release Date ECN Firmware Version
Micro-JLT GNSS™
User Manual v1.2
6 November, 2019 0.46
Modifications Added Section 3.3.12 GPS:GPVTG <int> [0,255]
Added Section 3.5.5 PTIMe:OUTput <ON|OFF>
Added Section 3.5.11 PTIMe:STAMp Subsystem
Added Section 3.5.12 PTIMe:STAMp:MODE <OFF|ASYnc|MEMory|OUTput|DIFFer>
Added Section 3.5.13 PTIMe:STAMp:SOURce <GPS|EXTernal|ALL>
Added Section 3.5.14 PTIMe:STAMp:DIFFer <ALL|EXT|GPS>
Added Section 3.5.15 PTIMe:STAMp:FILTer [OFF | REL | DUR | PPS]
Added Section 3.5.16 PTIMe:STAMp:FILTer:PPSecond <int> [1,100]
Added Section 3.5.17 PTIMe:STAMp:FILTer:1PPeriod <int> [1,604800]
Added Section 3.5.18 PTIMe:STAMp:LAST?
Added Section 3.5.19 PTIMe:STAMp:MEMory?
Added Section 3.5.20 PTIMe:STAMp:RESET
Added Section 3.5.21 PTIMe:STAMp?
Added Section 3.6.5 SYNChronization:SOURce:MODE:EDGE <NEGative|POSitive>
Added Section 3.6.7 SYNChronization:HOLDover:STATE?
Added Section 3.6.14 SYNChronization:OUTput:1PPS:RESET?
Added Section 3.6.15 SYNChronization:OUTput:1PPS:WIDTH <int> <ms | us> [100us,
500ms]
Added Section 3.7.4 DIAGnostic?
Added Section 4.4.1 Using the JLTerm Programming Terminal
Added Section 4.4.2 Using the Flash Magic Programming Utility
Added Chapter 7 Revision History
Updated Section 2.1 Powering Up the Unit
Updated Table 2.1Micro-JLT GNSS™ hardware connectors
Updated Section 2.1.3 Notes on Signal Interfacing and J1 Connector
Updated Section 2.1.4 Coaxial Connectors
Updated Section 2.3 Concurrent-GNSS Capabilities