Micro-JLT GNSS™ User Manual
46 © 2019 Jackson Labs Technologies, Inc.
scpi > diag?
EFControl Relative: 0.025000%
EFControl Absolute: 5
Lifetime : +871
3.8 MEASURE Subsystem
This subsystem regroups the queries related of some parameters that are measured on-board on the
Micro-JLT GNSS™. The list of the commands supported for this subsystem is the following:
MEASure:VOLTage?
MEASure:POWersupply?
MEASure:POWersupply:VOSCillator?
MEASure?
3.8.1 MEASure:VOLTage?
This query returns the EFC voltage applied to the OCXO.
3.8.2 MEASure:POWersupply?
This query returns the power supply voltage applied to the Micro-JLT GNSS™ board.
3.8.3 MEASure:POWersupply:VOSCillator?
This query returns the power supply voltage applied to the OCXO which is around 10.45V nominal.
3.8.4 MEASure?
This query returns the result of the three following queries:
MEASure:VOLTage?
MEASure:POWersupply?
MEASure:POWersupply:VOSCillator?
3.9 SYSTEM Subsystem
This subsystem regroups the commands related to the general configuration of the Micro-JLT
GNSS™. The list of the commands supported for this subsystem follows:
SYSTem:COMMunicate:SERial:ECHO <ON|OFF>
SYSTem:COMMunicate:SERial:PROmpt <ON|OFF>
SYSTem:COMMunicate:SERial:BAUD <9600|19200|38400|57600|115200>
SYSTem:STATus?
To Next Page
Loading...
