EasyManua.ls Logo

Jandy VS FloPro - Save These Instructions

Jandy VS FloPro
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...

Thispumpisforusewithpermanentlyinstalledpoolsandmayalsobeusedwithhottubsandspas,ifso
marked.Donotusewithstorablepools.Apermanentlyinstalledpoolisconstructedinorontheground
orinabuilding,suchthatitcannotbereadilydisassembledforstorage.Astorablepoolisconstructed
sothatitmaybereadilydisassembledforstorageandreassembledtoitsoriginalintegrity.

Donotinstallwithinanouterenclosureorbeneaththeskirtofahottub.Thepumprequiresadequate
ventilationtomaintainairtemperatureatlessthanthemaximumambienttemperatureratinglistedon
themotorratingplate.


Chemicalspillsandfumescanweakenpool/spaequipment.Corrosioncancauseltersandother
equipmenttofail,resultinginsevereinjuryorpropertydamage.Donotstorepoolchemicalsnearyour
equipment.

Runningthepumpdryforanylengthoftimewillcauseseveredamageandwill
voidthewarranty.

Tominimizeriskofsevereinjuryordeath,thelterand/orpumpshouldnotbesubjectedtothepiping
systempressurizationtest.
Localcodesmayrequirethepoolpipingsystemtobesubjectedtoapressuretest.Theserequirements
aregenerallynotintendedtoapplytothepoolequipment,suchasltersorpumps.
Zodiac
®
poolequipmentispressuretestedatthefactory.
If,however,theWARNINGcannotbefollowedandpressuretestingofthepipingsystemmustinclude
thelterand/orpump,BESURETOCOMPLYWITHTHEFOLLOWINGSAFETYINSTRUCTIONS:
•Checkallclamps,bolts,lids,lockrings,andsystemaccessoriestoensuretheyareproperlyinstalled
andsecuredbeforetesting.
inthesystembeforetesting.
•WaterpressurefortestmustNOTEXCEED35PSI.
•WatertemperaturefortestmustNOTEXCEED100°F(38°C).
•Limittestto24hours.Aftertest,visuallychecksystemtobesureitisreadyforoperation.
:TheseparametersapplytoZodiacequipmentonly.Fornon-Zodiacequipment,consultthe
equipmentmanufacturer.
Page 5
ENGLISH
Jandy
®
FloPro™ Variable-Speed Pump Series VS-FHP
|
Installation and Operation Manual

Table of Contents

Related product manuals