Janome JUNO E1030 - Mechanical Adjustment; Presser Bar Height

8
6.0 mm
MECHANICAL ADJUSTMENT
PRESSER BAR HEIGHT
Thedistancebetweenthebottomofthepresserfootinuppositionandtheneedleplateshouldbe6.0mm.
1. Removethefaceplateandneedle.
2. Lowerthefeeddogbelowtheneedleplate.
 Place6mmthickblockunderthe presserfootandlowerthepresserfootlifter.
3. Loosenthehexagonalsocketscrew.Raisethepresserfootlifterandtightenthesetscrewrmly.
 Attachtheneedleandfaceplate.
NOTE:
Makesurethatthepresserfootshouldbeparalleltothefeeddogslotsintheneedleplate.
Feed dog slots
Zigzagfoot(A)
Feed dog
Block
Needle plate
Presserfootshouldbeparallel
tothefeeddogslots.
Hexagonalsocketscrew
Presserfootlifter