Janome JUNO E1030 - Displaying the Version of the Program

22
SELF-DIAGNOSTIC TEST
Buzzersoundsafterfewsecondswhentheself-diagnostictesthasbeennished.
Thetestresulthasbeendetermined.
CORRECT:
BuzzersoundsandLEDdisplays“0”
DEFECTIVE:
CautionbuzzersoundsandLEDdisplaysthedefectivepart
number.Refertopages19to21andxthedefectivepart.
EachtimeyoupresstheMODEkey,thedefectivepart
number(s)willbedisplayed.
Thedefectivepartnumber.
Refertopages19to21
“Stepsanditems”section.
Pressthereversestitchbuttontoreturnto01.
Turnthepowerswitchoffwhentheself-diagnostictestisnished.
TO DISPLAY THE VERSION OF THE PROGRAM
1. Turnthepowerswitchon
  whilesimultaneously
  pressingauto-lockbutton
  andneedleup/downbutton.
5. EachtimeyoupresstheMODEkey,theversionnumberwillbepartiallydisplayedinsequence.
 Example:805A-1-1.00-001
2. TheLEDdisplay
  willindicate“1”.
3. Pressthevalueset
  key oncetodisplay
  the“2”.
4. Pressthe MODE
  keyto.