Janome JUNO E1030 - Self-Diagnostic Test; Preparation; To Begin; To Enter Self-Diagnostic Mode

18
TO ENTER SELF-DIAGNOSTIC MODE:
Preparation:
 1.Turnthepowerswitchoff.
 2.Movethebobbinwinderspindletotheleft.
 3.Raisethefeeddog.
 4.Setthespeedcontrollevertotheleft.
 5.Removethepresserfootandraisethepresserfootlifter.
 6.Turnthehandwheeltowardyoutoraisetheneedletoitshighestposition.
NOTE:
 •Becareful:thesewingmachinemaystartrunninginitsownwhileintestmode.
 •Turnoffthepowerswitchbeforereplacinganyparts.
 •Repeatthediagnostictestuntiltheproblemhasbeenresolved.
To begin:
 Turnontheswitch.Ifanyofthefollowingproblemsoccur,taketherecommendedactionsintheorderthey
 areshown.
1.Themachinedoesnotrespondwhenthepowerswitchisturnedon:
 •Checkeachconnectorconnection.
 •Replacetheswitchingregulator(withthemachinesocket).
 •ReplacetheprintedcircuitboardA.
2.Thesewingmachinelampdoesnotlightup:
 •BesureallconnectorsareconnectedtothecircuitboardLandAproperly(Refertopage23).
 •ReplacetheprintedcircuitboardL.
 •ReplacetheprintedcircuitboardA.
SELF-DIAGNOSTIC TEST
1. Turnthepowerswitchonwhile
  simultaneouslypressingauto-lock
  buttonandneedleup/downbutton.
2. TheLEDdisplay
  willindicate“ 1”.
3. Pressthe MODEkey
to enterthe
  self-diagnosticmode.