EasyManua.ls Logo

Janome Memory Craft 4400 - Needle Threader

Janome Memory Craft 4400
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
• Needle threader
z
Lower the presser foot. Depress the needle threader
knob as far as it will go. The hook comes out through
the needle eye from behind.
q Needle threader knob
w Hook
x Draw the thread down around the threadre guide and
under the hook.
e Threader guide
c Release the threader knob slowly while holdeing the
thread end with your hand. A loop of the thread is
pulled up through the needle eye.
v Remove the loop from the threader and pull out the
thread end from the needle eye.
z
x
c
v
q
w
w
e
NOTE:
The needle threader works well with the threads #50-100
and needles #11-16, the blue tipped needle as well.

Table of Contents

Related product manuals