36
v After attaching sensor buttonhole foot, raise the foot
lever once to assure spring is in proper position to
avoid any gap. Insert corner of fabric under the foot.
Press the Up/down needle button twice.
Remove the fabric to the left to draw both threads
under the foot.
Insert the garment under the foot, and lower the needle
at the starting point.
Then lower the automatic buttonhole foot.
If there is a gap, it may cause an uneven buttonhole
stitch length as shown.
y Mark
u Starting point
i Foot holder
o No gap
!0 Spring holder
!1 Uneven stitch results
Starting sewing
b
After sewing the buttonhole stitch, the machine stops
automatically.
Sewing steps:
Step 1
..........
The buttonhole will be automatically sewn
first: the front bartack and left row.
Step 2
..........
Next, the right row.
Step 3
..........
Last the back bartack and locking stitch.
Raise the presser foot.
To sew another buttonhole, press 08 on the number key,
then depress the foot control.
For buttonhole stitches ( ), you can repeat sewing
without pressing keys.
Raise the presser foot and lower the foot again.
............
............
............
v
b
i
o
!0
!1
y
u
To Next Page
Loading...
