Janome Memory Craft 4400 - SECTION V CARE OF YOUR MACHINE; Care of Your Machine; Cleaning the Hook Race and Feed Dogs

64
Care of Your Machine
q Screw driver w Set screw
e Needle plate r Bobbin holder
t Lint brush y Feed dogs
u Hook race i Soft, dry cloth
Press the needle Up/down button to raise the needle and
unplug the machine before cleaning.
Do not dismantle the machine other than explained on
this page.
Do not store the machine in a high-humidity area, near a
heat radiator or in direct sunlight.
Clean the outside of the machine with a soft cloth and
neutral soap.
Cleaning the Hook Race and Feed Dogs
z Remove the presser foot and needle. Remove the
screw on the left side of the needle plate with the
screwdriver supplied with the machine.
x Remove the needle plate and take out the bobbin.
Lift up the bobbin holder and remove it.
c Brush out dust and lint inside the bobbin holder.
v Clean the feed dogs and the hook race with the lint
brush.
b Clean the inside of the bobbin holder with a dry cloth
or a lint brush.
* Wipe out gently with soft, dry cloth. You may also use a
vacuum cleaner.
Replacing the Bobbin Holder
q Bobbin holder
w Stopper
e Knob
r Needle plate guide pins
t Screwdriver
y Guide holes
z Insert the bobbin holder so that the knob fits next to
the stopper in the hook race.
x Insert the bobbin.
c Replace the needle plate, inserting the two needle plate
guide pins into the holes in the needle plate.
Replace the screw.
z
x
c
v
b
zx
c
SECTION V CARE OF YOUR MACHINE
q
q
w
e
r
t
y
w
e
r
t
r
t
y
u
i