33
Sewing Buttons
q Stitch pattern: 05
w Presser foot: Satin stitch foot F
e Feed dogs: Down
z Turn the handwheel by hand five times and raise the
needle to the highest point.
Match the holes on the button to the horizontal slot on
the presser foot.
Lower the foot to hold the button in place.
Lower the feed dogs.
Press the stitch width button “ +” or “–” so the needle
will enter the left hole of the button.
Turn the handwheel so the needle will enter the right
hole of the button.
* Readjust the stitch width if necessary.
x Place a pin on the foot and stitch ten times.
After you finish sewing, cut the thread but leave 20 cm
(8 ˝) of thread on the wrong side of the fabric.
q Pin
c Bring the needle thread between the button and the fabric
through the hole in the button. Pull the needle thread to pick
bobbin thread up to the right side of the fabric. Wind the
threads to form a shank and knot them together.
Note: When sewing on the button is completed, raise the
feed dogs.
The feed dogs must always be up for normal sewing.
w Upper thread
e Lower thread
r Shank
t Fabric
qw
e
w
e
r
t
z
x
c
q
To Next Page
Loading...
