35
• Sewing preparation
q
Stitch pattern: 08
w Presser foot: Automatic buttonhole foot R
* When you select the buttonhole stitch, the screen
indicates the message: “PULL DOWN BH (Button
hole) LEVER” for a few seconds.
z Attach the automatic buttonhole foot R. Make sure the
groove on the holder catches the pin on the foot, when
lowering the presser foot.
q Groove
w Pin
x Pull the button holder to the back, and place the button
in it.
Push it together tightly on the button.
e Button holder
If the button is extremely thick, make a test buttonhole.
If it is difficult to fit the button through the test
buttonhole, lengthen the size by pulling the button
holder on the back to increase length.
r Gap
c Pull the buttonhole lever down as far as it will go.
t Buttonhole lever
q
w
z
x
c
R
q
w
r
e
t
To Next Page
Loading...
