Janome Memory Craft 4400 - Editing Function (2); Uniform Width, Length Adjustment; Editing Function (3); Custom Stitch Sizing

63
Editing Function (2)
• Uniform width, length adjustment
q Stitch width key
w LCD screen
e Stitch patterns
r Pre-set stitch width before change
t Stitch width at 5.0 after selection
The entire programmed stitch pattern is memorized as one
stitch.
The stitch length, stitch width and the of the patterns can
be adjusted manually as shown.
Example: To adjust the zigzag width:
z Press the Mode key and select A Mode
x Input stitch patterns 53, 51 ,53.
c Press stitch width key.
v Press “ – ” key to set the stitch width at “5”.
Editing Function (3)
• Custom stitch sizing
q Editing key
w LCD screen
e Stitch patterns
Adjust the stitch width and length of the memorized
individual patterns.
(Example): To change the length and width of a
particular pattern (Stitch patterns 53, 51, 53)
z Press the Mode key and select A Mode.
x Press “EDIT” key.
c Press the stitch width key “+”or “–” to slide the cursor
where you would like to change the stitch pattern
length.
v Press “ ” Message key.
b Press Elongation key twice to get “ x2 ” length.
n Press “ ” Message key.
m Press a“EDIT” key.
x
c
v
x
c
v
b
n
m
qw
e
r
t
qwe