144
Editing program
Uniform stitch adjustment (Modes 2 and 3 only)
The stitch width and length of the programmed stitch
patterns can be uniformly altered.
Example 1: To alter the stitch width of the programmed
pattern 27 and its mirror image in mode 3.
z Shift the cursor to the right of the last programmed
pattern q.
x Press the stitch width adjustment button to alter the
stitch width w.
NOTE:
Stitch length can also be uniformly altered when patterns
of the same category (satin stitches or stretch stitches)
have been programmed.
Start sewing. The programmed patterns will be sewn in the
uniform width.
e Default width (7.0)
r Uniformly altered width (5.0)
If you wish to alter the stitch length or width after sewing
the programmed patterns, press the edit key then follow
steps z and x above.
Unified needle drop position
The needle drop position of the programmed patterns will
vary depending on the combination:
t Unified to the left when combining the patterns with
the left needle position and the center needle position.
y Unified to the right when combining the patterns with
the right needle position and the center needle position.
u Unified to the center when combining the patterns with
the left needle position and the right needle position.
i Unified to the center when combining the patterns with
the left, right and center needle positions.
e
r
q
w
tyui
To Next Page
Loading...
