42
z Place the bobbin in the bobbin holder with the thread
running off counterclockwise.
q Thread
w Bobbin holder
Inserting the bobbin
(A)
q
w
(B)
x Guide the thread into notch (A) on the front of the bobbin
holder.
c Draw the thread to the left, sliding it between the tension
spring blades.
v Continue to draw the thread lightly until the thread slips
into side notch (B).
b Pull out about 10 cm (4˝) of thread to the rear.
Refer to the threading chart shown on the hook cover
plate. Attach the hook cover plate.
e Threading chart
z
x
c
v
b
e
To Next Page
Loading...
