8
WARNING:
While in operation, always keep your eyes on the
sewing area, and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug the
machine from the power supply:
- when leaving the machine unattended.
- when cleaning the machine.
Do not place any objects on the foot control.
GETTING READY TO SEW
Connecting the Power Supply
z First make sure the power switch q is off.
x Insert the machine plug w of the power supply cable
into the machine socket e.
c
Insert the power supply plug r into the wall outlet t,
and turn the power switch q on.
q Power switch
w Machine plug
e Machine socket
r Power supply plug
t Wall outlet
If you want to use the foot control, pull out the cord from
the foot control and insert the pin connector into the jack
on the machine.
z
First make sure the power switch q is off.
x Insert the machine plug w of the power supply cable
into the machine socket e.
c Draw out the cord from the foot control and insert the
pin connector r into the jack t on the machine.
v Insert the power supply plug y into the wall outlet u,
and turn the power switch q on.
q Power switch
w Machine plug
e Machine socket
r Pin connector
t Foot control jack
y Power supply plug
u Wall outlet
NOTE:
The start/stop key does not work when the foot control
is connected.
Operating Instructions:
The symbol “O” on a switch indicates the “off” position of
the switch.
For the U.S.A. and Canada only
Polarized plug (one blade wider than the other):
To reduce the risk of electric shock, this plug is intended
to t in a polarized outlet only one way. If it does not t
fully in the outlet, reverse the plug. If it still does not t,
contact a qualied electrician to install the proper outlet.
Do not modify the plug in any way.
NOTE:
Make sure to use the power supply cable that came
with the machine.
If you turn off the power switch, wait for 5 seconds
before turning it on again.
c
e
w
q
z
c
r
t
z
v
q
t
r
w
y
u
e
To Next Page
Loading...
