Janome Memory Craft 6700P - Attaching the Dual Feed Foot AD; Attaching the Professional Grade Foot HP; Attaching the Darning Foot PD-H

16
Attaching the Dual Feed Foot AD
z Attach the dual feed holder to the presser bar.
q Dual feed holder
x Tighten the setscrew with your ngers.
Push the dual feed link to engage it with upper feed
drive.
w Dual feed link
e Upper feed drive
c Lower the presser foot lifter. Lower the needle to the
lowest position by turning the handwheel.
v Tighten the setscrew securely with the screwdriver.
z x
c
v
Attaching the Darning Foot PD-H
Attach the darning foot PD-H to the presser bar by
putting the pin on the needle clamp screw.
q Pin
w Needle clamp screw
Tighten the setscrew rmly with the screwdriver.
Attaching the Professional Grade Foot HP
Attach the professional grade foot HP to the presser bar.
Tighten the setscrew rmly with the screwdriver.
w
q
e
w
q
w