80
Twin Needle Sewing
Preparation
Replace the needle with the twin needle supplied with
the standard accessories.
CAUTION:
Turn the power switch off or press the lockout key
before changing the needle.
Do not use twin needles other than one included in
the standard accessories, otherwise the needle may
hit the needle plate, foot or hook and break.
q Lockout key
q
z
x
cv
b
n
,
.
⁄1
⁄0
Place two spools of thread on the spool stand.
To thread the left spool thread, draw the thread from the
left spool and pass them through the threading points
from z and c to n.
Slip the thread through the slit of the lower thread guide m,
(behind the lower needle guide hole) then pass through
points . and ⁄1 as illustrated.
To thread the right spool thread, draw the thread from the
right spool and pass them through the threading points
from z to n.
Draw the thread through the hole of the lower thread
guide ,, then pass the thread to the point ⁄0 as
illustrated.
Make sure that the two strands of thread from the spools
do not get tangled.
NOTE:
• Threading from points c to n is the same as for a
single needle (refer to page 22-23).
• The needle threader cannot be used with the twin
needle.
m
To Next Page
Loading...
