Janome Memory Craft 6700P - Care and Maintenance; Cleaning the Hook Area

97
Recalling a Stored Combination
z Press the folder/FS key.
The selection window appears when a single pattern is
displayed on the LCD screen.
Press the numeral key “0” to display the memory recall
window.
q Folder/FS key
w Selection window
x Turn the jog dials to select the memory address where
the desired pattern combination is stored.
Turn the stitch width adjusting dial to turn the address
pages.
Turn the stitch length adjusting dial to move the cursor
to select the address.
Press the numeral key “2” to recall the stored
combination.
e Address page
r Cursor
Deleting a Stored Combination
z Select the memory address storing the pattern
combination you want to delete by turning the jog dials.
Press the numeral key “3”.
z
x
e
r
r
w
z
x
x The conrmation message appears.
Press the memory key to delete the stored
combination.
t Memory key
NOTE:
To close the memory recall window, press the clear
key.
NOTE:
The stored combination cannot be recalled if the
straight stitch needle plate or professional grade
needle plate is attached, or the twin needle mark is
displayed on the LCD screen (refer to page 81).
t
q
e
NOTE:
If the favorite stitch function is turned off, or a stitch
pattern combination is displayed on the LCD screen,
the memory recall window will be displayed when the
folder/FS key is pressed (refer to page 35).