69
→ →
→
Tacking is used to reinforce pockets, crotch seams and
belt carriers where extra strength is needed.
Sewing
Lower the needle at the starting point.
Lower the foot and sew until the machine stops
automatically.
The machine will sew a tacking 1.5 cm (9/16˝) long
automatically.
q Tacking
w Starting point
e 1.5 cm (9/16˝)
w
e
q
w
e
Sewing a shorter tack
To sew a tack shorter than 1.5 cm (9/16˝), rst stop the
machine after sewing the required length, and then press
the reverse key.
The required length has been determined.
Continue sewing until the machine stops automatically.
q Starting point
w Required length
e Tack length
r Reverse key
Sewing the same size tack
When nished sewing, the “M” mark t will appear.
This indicates the tacking size has been memorized.
To sew another tack in the same size, simply start the
machine and it will stop automatically when nishing
sewing.
Sewing the tack at a different size
To sew the next tack at a different size, press the
startover key and start sewing from the beginning.
y
Startover key
q
Tacking
q Pattern: MODE 2: 034
w Presser foot: Satin stitch foot F
e Thread tension: 3-6
r Foot pressure: 3
w
e r
q
r
t
y
To Next Page
Loading...
