100
Problems and Warning Signals
If a buzzer sounds and the LCD screen shows a warning sign, follow the guidance below.
Warning Sign Cause Try this
The foot control is out of order. Contact the service center
or the store from whom the
machine was purchased.
The start/stop key is pressed with the foot control
connected.
Disconnect the foot control.
The power is turned on while depressing the foot control Release the foot control.
The machine is turned on with the needle in the down
position.
Turn the handwheel to raise
the needle.
The machine is started without lowering the presser foot.
The presser foot is raised while sewing.
Lower the presser foot and
start the machine.
The bobbin winding key is pressed when bobbin winder
stopper is at the right position.
Shift the bobbin winder
stopper to the left for bobbin
winding.
The machine is started without lowering the buttonhole
lever.
Lower the buttonhole lever
and start the machine again.
Problems and Warning Signals
If a buzzer sounds and the LCD screen shows a warning sign, follow the guidance below.
To Next Page
Loading...
