47
v Close the zipper and spread the fabric open at with
the right side facing up.
Attach the Zigzag foot A.
Adjust the stitch length to 5.00, needle drop position to
4.5 (default value) and thread tension dial to 1.
Baste the opened fabric and zipper tape together.
i Basting
o Zipper tape
b Attach the zipper foot E.
Adjust the stitch length to default value, needle drop
position to 0.5–1.5, thread tension dial to “4”.
Backstitch across the end of the opening 0.7-1 cm
(3/8˝) and turn the fabric 90 degrees.
!0 0.7-1 cm (3/8˝)
n Stitch through the garment and zipper tape, guiding
the zipper teeth along the side edge of the foot.
Stop about 5 cm (2˝) from the top of the zipper.
Unfasten the basting stitches.
!1 5 cm (2˝)
!2 Basting stitches
i
o
!0
v
b
n
m
CAUTION:
Be sure that the needle do not strike the presser foot
when the zipper foot or zipper teeth is attached and
needle drop position is adjusted.
m Lower the needle into the fabric, raise the foot, and
open the zipper.
Lower the foot and stitch the remainder of the seam,
making sure the fold is even.
Remove the basting threads after seaming.
!1
!2
!2
To Next Page
Loading...
