60
n
m
,
m After you nish buttonhole sewing, push the
buttonhole lever up as far as it will go.
, Place a pin just below the bartack at each end to
prevent accidentally cutting the threads. Cut the
opening with the seam ripper. Use an eyelet puncher*
to open a keyhole buttonhole.
n The buttonhole is sewn automatically in the sequence
shown. When the buttonhole is nished, the machine
will stop automatically with the needle in the up
position. Press the thread cutter key and remove the
fabric.
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of
buttonhole stitches over the previous stitches.
After the buttonhole is nished, simply start the machine
again.
Do not raise the foot or buttonhole lever.
Do not reselect the pattern.
NOTE:
This function is disabled if Thread Cut after Auto-Lock
option is turned on (refer to page 34).
* An eyelet puncher is not included with this machine.
To Next Page
Loading...
