121
CARE AND MAINTENANCE
Cleaning the Hook Area
Clean the hook area at least once a month.
Remove the needle plate (refer to page 19).
Turn the power switch off and unplug the machine.
Remove the needle and presser foot.
NOTE:
Do not dismantle the machine in any way other than as
explained in this section.
Take out the bobbin and bobbin holder.
q
Bobbin holder
Clean the bobbin holder with a lint brush.
Apply a few drops of the bobbin holder cleaner (included
in the standard accessories) to a soft cloth and wipe the
bobbin holder both inside and outside.
w
Lint brush
e
Soft cloth
Clean the feed dog and auto thread cutter device with
the lint brush.
r
Feed dog
t
Auto thread cutter device
Clean the inside and lip of the hook race with a soft cloth.
Insert the bobbin holder so that the knob ts next to the
stopper in the hook race.
Insert the bobbin.
y
Knob
u
Stopper
Attach the needle plate, presser foot and needle.
q
e
w
r
t
u
y
To Next Page
Loading...
