122
Cleaning the Inside of the Thread Guide
Clean the inside of the thread guide plate under the top
cover at least once a month.
Remove the needle thread and remove the thread guide
plate by pulling it up.
q
Thread guide plate
Remove lint and dust from the brush on the underside of
the thread guide plate using a lint brush.
w
Brush on the thread guide plate
Clean the area around and under the pre-tension leaf
with the lint brush.
e
Pre-tension leaf
Set the thread guide plate on the machine, inserting the
tenons into the slots. Push the thread guide plate down to
snap it in place.
r
Tenon
q
w
e
r
e
To Next Page
Loading...
