80
t
Cloth Guide
t
-1 Calibration of the default position
Attach the embroidery unit.
The default position of the cloth guide is 15 mm (5/8)
from the center needle drop position. However, you can
ne tune the default position of the cloth guide.
Press the YES key and a warning message will appear.
Press the OK key and the carriage will move to the
standard position.
Press the key or key to adjust the position of the
cloth guide.
Press the key to back to the default cloth guide
position.
Press the OK key and the carriage will return to the home
position.
t
-2 Saving favorite position
If you have set the cloth guide to your favorite position, 6.4
mm (1/4) in the manual setting window for example (refer
to page 35), you can save this position for future use.
To save favorite position, press the ON/OFF key to turn
ON the save position option.
Press the next page key to show the next menu.
t
t
-2
t
-1
To Next Page
Loading...
