Janome Quilt Maker Pro 18 VERSA - Adjusting the Base-Plate Feet; Base Plate Flatness Check; Shim Washer Adjustment

Janome-America.com
Page 15
6. Adjusng the Base-Plate Feet
Figure 6.1
Figure 6.2
Tools required: (5 mm handle hex tool)
Check:
1. The base plate must be adjusted so that the rubber
feet will sit at on a planed surface. Note: This is
done on a precision surface plate at the factory
during assembly.
If a correcon is necessary: Thin shim washers may be
used as shown in (Figures 6.1 and 6.2).